Seiko DPU-3445 User Manual download pdf (Page 12)

Geophysical Survey Systems, Inc. HandySan

User’s Manual

MN70-380 Rev B 2

HandyScan Operation

1. Install a charged battery.

2. Turn power On (switch is located on the back panel).

3. Wait until data screen appears (about 15 sec).

4. Check battery indicator (top right corner of the screen).

5. If a low battery is indicated, turn system off and replace.

Using Setup Table:

Press Set on the keypad to display setup table, then:

• Up/down arrows to select a parameter,

• Left/right arrows to change it.

Disp. Direction: normal / invert

Disp. Mode : B / AB

Amplitude : abs / offset

X-axis : distance / time

Depth : ns / -3 to 3

Contrast : (number)

Date/time : 05/10/2001

Data_No. : 1

Dist adj. : +0 [0.00m]

Output : printer / computer

Baud rate : 57600

Default : NO

Data Collection

1. Press and hold down Start button, you will hear a single beep that denotes that the system is

ready for data collection.

2. Move unit forward.

3. Slow down if signal sounds when moving.

4. Release Start button and press Mark to insert a mark into data, press and hold Start button

to continue collecting data. If the Start button is not depressed within ten seconds, the unit

will close the data file.

5. Release the Start button and press the Down arrow to close file (double beep).

1 2 ... 7 8 9 10 11 12 13 14 15 16

No comments

Seiko DPU-3445 User Manual Page 12