Seiko BX-900 Owner's Manual download pdf (Page 21)

Loading the paper

❏ Fanfold continuous paper

1. Move the paper select lever toward the front of the printer to set

the fanfold paper setting.

2. Set the print head adjustment lever . In general, position 1 is

used for one-part paper. (See page 15)

3. Remove the rear cover of the printer or open the rear cover to

lock the cover in the open position.

4. Release the tractor lock levers (upward), and move the right tractor to

the marked position as shown in the figure, and lock it in place.

5. Open both tractor covers and place the fanfold paper so that the tractor pins are aligned with the

holes in the paper. Carefully close both tractor covers.

6. After the paper is properly installed, re-adjust the left tractor to a position to keep the paper taut (but

not too taut) between the left and right tractors.

7. To load the paper, press the FF key on the front panel. The fanfold paper is fed to the top-of-form

position 14/60 inch (6mm) below the top edge of the paper. The top-of-form position can be

adjusted from 0/60 inch to 480/60 inches (8 inches = 203mm) in the basic setup options on page 31.

8. The paper bail automatically lowers to press the paper against the platen when the leading edge of

the paper feeds more than one inch onto the platen.

Rear Cover

Left Tractor Cover

Not Too Taut !!

Left Margin Marker

Tractor Cover

Tractor Lock Lever

Right Tractor

Releasing direction

2. Setting up

CAUTION

Be careful not to catch your finger when closing the tractor covers.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 145 146

No comments

Seiko BX-900 Owner's Manual Page 21