4-2
Changing DIP Switch 4.1.1
(1) Change procedures
DS is mounted on the interface board of the serial model and USB+ serial model printers.
1. As shown in the figure below, remove the two screws fixing the board and then grasp the cable hook in
the center to pull out the board.
2. When the board is pulled out, DS is mounted on the place shown as below. Use the tip of the driver to
change the switch.
3. After setting DS, insert the board straight as far as it will go and fix it with the screws again.
(NOTE) DS is not mounted on the interface board of the USB model and Ethernet model
printers. Do not pull out the board.
Comments to this Manuals