6-12
• Barcode
The reference point of the barcode is lower left. The next mapping start position shifts horizontally
for the barcode width.
• Raster bit image
The reference point of the raster bit image is upper left. The next mapping start position shifts
horizontally for image width.
The character and the image data are mapped as shown in Figure 6-1.
Graphics
Data Storage
into Print
Buffer
Figure 6-1 Mapping of Characters and Image Data
Transmit print data after executing "Page Mode Select" command or "Print Area Set in Page Mode"
command then specifying mapping start position. When mapping start position is not specified, the
position of mapping is undefined.
3. Direction of data mapping
It is possible to specify the direction of data mapping. See "Character Print Direction Specify in Page
Mode" command ("6.5.4 Print Position").
4. Print command processing
The commands that involve a print operation in the page mode are FF and ESC FF. Print commands in
the standard mode (LF, ESC 'J', etc.) do not result in actual printing, but only moving of the mapping
start position.
Comments to this Manuals