Seiko LP-1020L User's Guide download pdf (Page 10)

This device offers a manual feeding feature as a service

function. As this is a service function, we cannot assure the

picture quality and printing accuracy.

◆Manual feeding procedures

Adjust the paper guide.

Adjust the paper guide to the position where you will

set the cut paper for manual feeding.

Set the paper so that the printing surface is

face down.

When you insert the paper into the manual paper feed

inlet, the paper is drawn in and the paper is ready for

printing.

Caution

◆ Take care not to hurt yourself and damage the

device when handling the cutter.

◆ Handle the cutter blade with care so that you do

not break it.

◆ When sliding the cutter along the space, take

care not to cut the back of your hand on the sides

of the paper tray.

Close the paper roll drawer.

Gently push in the Roll 1 or Roll 2 drawer.

When the paper roll drawer is closed, the following

message appears.

(It will take about 30 seconds until paper feeding is

ready.)

Manual paper feeding (cut paper)

◆

Manual paper feeding procedure

Set the paper feeding mode.

When the PDL setup paper feeding mode is set to the

continuous or optimum mode, paper should be

manually fed only for the drawings for which the data

was processed immediately after the paper was fed into

the manual paper feeding unit (this function is called

"interrupt manual feeding function".)

When the PDL setup paper feeding mode is the manual

feeding mode, paper should be always fed from the

manual paper feeding unit. If no paper has been fed

into the manual paper feeding unit when data is

transferred, paper to be used is indicated on the display

(this function is called "continuous manual paper

feeding function".)

Refer to the User’s Guide for details of the paper

feeding mode.

Load the cut paper.

For cut paper and its setup method, refer to the

respective User’s Guide.

WA I T A MOMEN T

Note

◆ After closing the paper roll drawer, wait until the

“WAIT A MOMENT” message disappears before

opening the paper roll drawer again.

As the device initiates a paper detection just after

the paper roll drawer is closed, so opening the

paper roll drawer during this operation may

cause a paper jam.

After the replacement, the device will return to the

status before the paper roll was replaced.

Note

◆ If you change the type of paper roll, you must

change the setting of the paper menu.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 29 30

Comments to this Manuals

No comments

Seiko LP-1020L User's Guide Page 10

Comments to this Manuals

Related products and manuals for Plotter paper Seiko LP-1020L