Seiko 7C17 User Manual download pdf (Page 10)

Programming WORK Field Data:

WK Parameter Command Description

Refer to the photos and pendant descriptions above for a detailed explanation.

Command

list

WK data

parameter

Description

Group #1 Parameters

S+ ***.* SP*** Solder feeding forward, feeding amount

***.*mm, feeding speed ***mm/s

S- ***.* SP*** Solder feed reverse, feeding amount

***.*mm, feeding speed ***mm/s

CY1 ON TM*** Iron down and waiting time***sec..

CY1 OFF TM*** Iron up and waiting time*** sec..

TIM ***.* Time delay *** sec.

END WK step end

AIR **.* Air blow *** sec.

ACK When sliding, ACK(acknowledge) signal

gives the machine the slide stating timing

TEM *** Temperature setting. The command turns on

heater power and sets solder temperature.

WK command to do the step in the same time

Group #2 parameter (Press the ALT key to access this parameter group. (#1-#2 #2-#1)

OUT * TM*** External I/O output signal *** sec.

IN * External I/O input signal waiting

SET * Turn on output signal

RST * Turn off output signal

WST Wait the start signal

JMP Jump to other program to run multi

programs without stopping

TE2 *** Temperature setting without a waiting

“temperature alarm off”.

LDS *** Start (turn off) LD with ***A (5-42A).

LDR Reset (turn off) the LD.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 43 44

No comments

Seiko 7C17 User Manual Page 10