Seiko TM-L60 Operator's Manual download pdf (Page 78)

APPENDIX D Notes on Using the Drawer kick-out

Connector

1) Usage conditions of drawer kick-out connector (Refer to APPENDIX B).

Because drawer specifications differ greatly depending on the manufacture

and the part No., make sure that the specifications of the drawer to be

used meet the following conditions before connecting it to the drawer kick-

out connector of this printer. These conditions also apply to any devices

that use the drawer kick-out connector.

Any devices that do not satisfy all the following conditions must not be used.

[Conditions]

• A load must be provided between the drawer kick-out connector pins 4

and 2 or between 4 and 5.(* 1)

• When the drawer open/close singnal is used, the drawer open/close

switch must be provided between the drawer kick-out connector pins 3

and 6.(* 2)

• The resistance of the drawer open/close solenoid load shall be 24 Ω

or more, or the output current shall be 1 A or less.(* 3)

. Be sure to use the drawer kick-out connector pin 4 (24 V power output)

to drive the device. Never connect any other power supply to the

drawer kick-out connector. (* 4)

in this case the peak current is 1 A, and the energizing conditions

described in 2) must be followed.

NOTES: * 1. Operation of this printer with incorrenctly installed devices voids

the warranty.

* 2. Connecting devices other than the switch voids this printer’s

warranty.

* 3. if a device with the resistance of less than 24 Ω or the input

current of over 1 A is used, the resulting overcurrent could

damage the device.

* 4. Operation of this printer with devices other than those specified

voids the warranty.

-71-

1 2 ... 73 74 75 76 77 78 79 80 81 82 83 84 85

No comments

Seiko TM-L60 Operator's Manual Page 78